Short Track Models

Other => Buy/Sell/Trade => Topic started by: pdaly28 on January 08, 2018, 03:35:40 PM

Title: AMT upper A arms
Post by: pdaly28 on January 08, 2018, 03:35:40 PM

Hello.
      I am in need of 4 sets of AMT nascar upper A arms,painted or not.Any out there?

Title: Re: AMT or Monogram nascar upperA arms
Post by: pdaly28 on January 08, 2018, 03:53:07 PM

Thanks David,I'll keep looking.Actually the monogram upper A's with the cross member will work too.I am scratching a couple chassis.

Title: Re: AMT upper A arms
Post by: pdaly28 on January 08, 2018, 04:11:45 PM

Quote from: David Bogard on January 08, 2018, 03:45:24 PM

That's a tough "get" Pat. I had an old opened kit once that didn't have them and since I had some in a new kit, I used them as a pattern and made a pair from  .040 sheet styrene. After they were good I simply cut out the middle part to open them up and give them a little better look. They "worked" well but were a bit of a pain to make.

I've built a couple out of paper clips and styrene that look ok and i'll bet are a lot easier that just styrene.just a thought