Short Track Models
Construction Topics => Tips-tricks => Topic started by: Brian Conn on July 05, 2018, 06:57:03 PM
-
Building my first dry sump engine....what is everyone using for the stainless steel braided oil lines ...pan to pumps, pumps to reservoir, etc. etc. looking for something around 1mm (+-)
-
Detail Master. Go to the site and they have all the A/N fittings, Braided line sizes including a chart for sizes.
-
OH YEA...forgot about them....
Any ideas on an oil tank reservoir? Teds Modeling Market Place shows only an Aluminum tank which he is out of.....anyone else carry one? It can be a resin cast
-
Jack one out of an early Monogram Ford or GM Nascar kit.
-
Jack one out of an early Monogram Ford or GM Nascar kit.
I see your Jack and raise you a pair of Deuces 8)......
Don't know which kit this comes from...got it out of the salvage bin at the LHS...its the on piece combo dry sump pan, starter and 3 stage pump. I need to move the 3 stage pump to the Right side due to clearance issues with the fuel pump and area where the oil line fitting screws onto the original oil filter fitting...another piece that I will make a mold of and resin cast.
I'm trying to get my building Mojo back with that Mustang II dirt Late Model that I was working on. :-\