Short Track Models

Construction Topics => Tips-tricks => Topic started by: David Bogard on November 21, 2017, 05:44:17 PM

Title: Pre-wired distributors
Post by: David Bogard on November 21, 2017, 05:44:17 PM

If you use these, what brand do most of you use?

Title: Re: Pre-wired distributors?
Post by: pdaly28 on November 21, 2017, 09:06:12 PM

MAD only!

Title: Re: Pre-wired distributors
Post by: pdaly28 on November 25, 2017, 09:13:38 PM

I would love to see some one make 45 degree boots,pain for us older guys to do.but I do like the mad distributors

Title: Re: Pre-wired distributors
Post by: pdaly28 on December 02, 2017, 04:02:41 PM

I do like your boot installation process,and the wires seem a little larger on this and I like that  too!i am thinking of fogoing this on the current pinto since I am using a sbc and big donkey headers,we'll see...................thanks david

Title: Re: Pre-wired distributors
Post by: Bob P. on December 02, 2017, 04:47:17 PM

Thanks everyone for your suggestions on mag suppliers.

I just received three magnetos from MAD. I'm pleased with them, they look very realistic.
I never worked with ones that had the insulated wire for the boots. I always used heat shrink tubing.
I'll see how this goes.

Bob

Title: Re: Pre-wired distributors
Post by: Bob P. on December 02, 2017, 06:29:05 PM

Thanks David.

Bob