Author Topic: louvers  (Read 1762 times)

0 Members and 1 Guest are viewing this topic.

djdrews

  • Newbie
  • *
  • Posts: 23
louvers
« on: February 12, 2020, 02:12:59 PM »
Anyone out there have a good way to make louvers?

Marty W

  • Sr. Member
  • ****
  • Posts: 411
Re: louvers
« Reply #1 on: February 12, 2020, 06:04:58 PM »
Where are they going?

Maybe they are going to Louvers Lane. I couldn't resist.

djdrews

  • Newbie
  • *
  • Posts: 23
Re: louvers
« Reply #2 on: February 13, 2020, 07:43:17 AM »
I would like to put them on the hood and trunk lid.

Brian Conn

  • Hero Member
  • *****
  • Posts: 689
  • Banned for the greater good
    • Alumilite Molding & Casting
Re: louvers
« Reply #3 on: February 13, 2020, 10:05:50 PM »
   Model railroading would be a good source for louvers i.e Tichy..... I believe that Plaastruct offers plastic louvers , another source would be Walthers
The only heroes in Washington are buried just outside of it in Arlington

Brian Conn

  • Hero Member
  • *****
  • Posts: 689
  • Banned for the greater good
    • Alumilite Molding & Casting
Re: louvers
« Reply #4 on: February 15, 2020, 06:17:39 PM »
.....I was reminded of this from David Bogard.....
https://www.tedsmodelingmarketplace.com/louvers-3d-1-25-1-24/
  I would say that if your wanting to do these on a hood and trunk lid this this looks to be the way to go.
The only heroes in Washington are buried just outside of it in Arlington