Author Topic: Tobias Modified (Read 1958 times)

dirtmodwrench · « **on:** July 19, 2020, 08:00:43 PM »

Stared with a standard frame from a Tobias kit. Modifying both ends with suspension changes. First up added a torsion bar rear setup. Used brass tubing for the torsion tubes and will make some torsion arms.

Tobias Standard Frame by Mark Shea, on Flickr

Tobias Torsion Rear by Mark Shea, on Flickr

Tobias Torsion Left Rear by Mark Shea, on Flickr

Tobias Left SIde View by Mark Shea, on Flickr

Bob P. · « **Reply #1 on:** July 20, 2020, 06:15:02 PM »

Looks good, I like the torsion bar set up. Looking forward to seeing the front also.

Bob

Gary Davis · « **Reply #2 on:** August 03, 2020, 02:54:32 PM »

There's some very good fab work going on here for sure! Really looking good...

dirtmodwrench · « **Reply #3 on:** August 10, 2020, 08:37:56 PM »

Thanks for the feedback. Was on vacation last week and didn't have good internet reception so couldn't respond. Decided to tackle a little body work when I got back. Shortened up the trunk and trimmed the lower rear quarters. Will get back on the chassis and finish the front suspension work next.

Mustang off frame by Mark Shea, on Flickr

Mustang trimmed off frame by Mark Shea, on Flickr

Mustang on frame by Mark Shea, on Flickr

Mustang trimmed and primered by Mark Shea, on Flickr